Old Feed Was Corrodid in Ground
Chasing down electrical gremlins in a motor vehicle can be an exercise in frustration—the kind of frustration that makes young men old and old men talk to themselves.
An electrical problem can often be traced to a single source: a bad ground connection. A bad ground can cause noise in an audio system, make electric fuel pumps run hot or produce low pressure, and make electronic engine controls do weird things.
Make Sure You Have a Quality Ground Point
Many think that as long as the accessory's ground wire is touching some part of the vehicle, it is grounded. That is not the case. You must make sure the ground wire is attached at a point that is free of paint, rust, or plating. Paint on body panels and the engine acts as an insulator, resulting in a bad ground connection.
Best Practice for Grounding Accessories to an Engine
If you are grounding an accessory to the engine, it's good practice to run a ground wire directly to the alternator case and make sure there is no paint between the starter and the engine block mounting surface.
Using a Voltmeter/Multimeter to Test the Connection
If your accessory still doesn't work properly after redoing the grounds, you will need a voltmeter or multimeter to trace the wiring. Set the voltmeter to read ohms (resistance) and probe the battery's negative stud and ground connection on the accessory (the ground terminal on an amp, for example). If you have a reading less than five ohms, the ground is okay.
If the resistance is okay but the accessory still isn't working right, set the voltmeter to DC current (voltage). Turn the accessory on and retrace the grounding path as you did before. The voltage should be no greater than .05 volts under load. If you find a point where voltage is present, then you need to add a bonding strap or find a new grounding point so no voltage is present at any of the grounding points.
If the reading is higher, you need to probe the grounding path between the accessory and the battery. Starting at the battery, run the voltmeter probe from the battery to the first grounding point, usually a fender on muscle cars and trucks. Continue to where the fender attaches to the main body, and from there to the accessory. If you find a point of high resistance (over five ohms), you will need to attach a bonding strap or wire between the panels or parts where resistance is highest.
Consider Engine-to-Chassis Ground Strap
One of the best things you can do to help ensure a properly grounded vehicle is to replace or add an engine-to-chassis ground strap; Taylor makes a nice four-gauge, braided stainless steel strap ideal for most vehicles.
Consider Larger Gauge Wire
If you are adding a number of accessories or ones that draw a large amount of current, you should also replace the battery-to-chassis ground with a larger gauge wire. That's because the factory ground wire is usually a less-than-adequate 10 or 12 gauge. A ground wire must be as large as the positive, or supply, wire to the battery.
Hopefully you will never have to experience the joy of tracing a bad ground. But if you find yourself in such a situation, these tips will help make the job go smoother—and get your ride back on ground level.
…
For more information on the basics of automotive electrical troubleshooting, check out our friend Eric the Car Guy's two-part video series covering it:
Electrical Troubleshooting Basics, Part 1
Electrical Troubleshooting Basics, Part 2
…
Parts List
- Sunpro AutoTroubleShooter Digital Multimeter (SUN-CP7677)
- Actron AutoAnalyzer Multimeter (SUN-CP7665)
- Taylor Braided Engine Ground Strap, Four-Gauge, 14-inch (TAY-148014)
Source: https://www.onallcylinders.com/2019/07/24/how-to-diagnose-electrical-ground-issues/
Post a Comment for "Old Feed Was Corrodid in Ground"